I got a lovely email today from Mr. Steve L. of Massachusetts. The Subject line read "Christmas Presents"
Steve purchased seven of the partial version of the 3" Machinist clamp kit and really took them over the top!
Here is what Steve had to say.
"Hello Doug,
Very much enjoyed machining these clamps and I'm sure the male members of my family will put them to good use. I purchased from your company the side plates, button head screws and drawings. The rest of the parts are from bar stock. The brass spacers are 932 bearing bronze. The jaws, bearing pin washers and the handle keepers are 360 brass. The handle shaft is 01 drill rod. The spacer pins and the screw are 12L14 cold rolled steel.
Thanks for your creativity, and for sharing it!
Best regards,
Steve"
Steve purchased seven of the partial version of the 3" Machinist clamp kit and really took them over the top!
Here is what Steve had to say.
"Hello Doug,
Very much enjoyed machining these clamps and I'm sure the male members of my family will put them to good use. I purchased from your company the side plates, button head screws and drawings. The rest of the parts are from bar stock. The brass spacers are 932 bearing bronze. The jaws, bearing pin washers and the handle keepers are 360 brass. The handle shaft is 01 drill rod. The spacer pins and the screw are 12L14 cold rolled steel.
Thanks for your creativity, and for sharing it!
Best regards,
Steve"